Skip to main content
Generators turn a conversation into digital signals. You write messages and choose how devices communicate; Oryx draws the bits on the timeline. The chat and the signal show the same exchange. With UART and I2C, you can create the full range of signals these generators support: different frames, data, addresses, replies, pauses, and simultaneous conversations. Combine the settings to build anything from a simple exchange to several ports or buses at once. Each guide describes its available options.
UART and I2C generators work in digital mode. Available ports, buses, and channels also depend on the editor and your plan.

On your phone

The phone follows the same steps as the computer —welcome, new project, the signal and testing it—, and the signal is built with the generators.
1

New project

On the welcome screen, New project asks how to start, just like on the computer: Design a signal with a generator shows the types (choose Digital or Analog and tap one) and Import brings an image or a file; when it is done, the optimizer says what signal it is and opens it in its generator.
2

Write or adjust

The generator opens full screen; the chat ones (UART, I2C, SPI, equations) take the whole height, like a messaging app. Tap a message to see its actions. A signal is made with a single generator: to combine several, continue on your PC.
3

View signal

View signal, in the top bar, opens the signal page: play it, zoom in, read the protocol interpreter under each channel, save it, export it or test it on the device. It turns on once something is drawn.
Back goes from the signal to the generator, and from the generator to the welcome screen, which shows your signal under Pick up where you left off with Keep editing, View signal and Save (below, smaller, what you need to start another project). Opening the signal from there is just for looking: back returns to the welcome screen. To draw by hand cell by cell, continue on your computer: the same signal is waiting for you there.

Get started

1

Open Generators

In the digital editor, click Generators beside the timeline and choose UART or I2C.
2

Set up the exchange

In UART, choose TX for a sent message or RX for a reply. In I2C, add or mention a device and choose Write or Read.
3

Type and add

Enter text, hexadecimal bytes (0x), or decimal numbers (123). A draft appears in the signal while you type. Press Enter or the add button to commit it.
4

Inspect the signal

Each message shows its byte and step counts. Use Show in the signal to locate it. The protocol interpreter explains the fields beneath the channels.

Work with messages

You can edit, duplicate, reorder, or delete a message. The panel redraws its lines when you change the conversation or settings. Clear all removes the generator’s messages. Messages are saved with the project so the chat returns when you reopen it.
If you edit a signal by hand and the generator can no longer read it, the panel warns you. Your next generator change rebuilds its lines from the chat messages. You can undo that change.

UART generator

TX and RX messages, character formats, multiple ports, and pauses.

I2C generator

Devices, addresses, reads, writes, and multiple buses.