Skip to main content
Step count determines signal length. Zoom only changes how much of it is visible.

Step count

A new project has 16 steps by default. You can change this separately for each mode in General Settings → Initial number of steps.

Other ways to add steps

  • Dragging with the right button while holding Shift past the end of the signal: the missing steps are created up to where you release.
  • Pasting or inserting a template longer than what is there.
Without Shift, the right-button drag only moves the view. You can press or release Shift mid-drag.

The padlock

The padlock prevents changes to signal length. While enabled:
  • You cannot delete or insert steps.
  • You cannot insert or unfold templates.
  • The right drag does not create steps.

Fit (analog only)

The Fit button in the header trims the empty steps on both sides and leaves only the signal on screen. It is available only in analog mode: a digital signal has a level at every step, while an analog signal is defined between its first and last points. Fit zoom only changes the view; it does not trim steps.

Zoom

Moving around the signal

  • Mouse wheel and the scroll bar.
  • Right-button drag over the timeline.
  • If you drag a selection to the edge of the screen, the view follows on its own, faster the closer to the edge you are.